All tests / FAA Instrument Rating (IRA) knowledge test / IFR departures and en route operations
FAA Instrument Rating (IRA) knowledge test: IFR departures and en route operations practice
209 practice questions on IFR departures and en route operations for the FAA Instrument Rating (IRA) knowledge test. Each answer comes with an explanation and the official source.
Tests ODPs, SIDs, climb gradients, low/high en route charts, changeover points, holding pattern entries, and fuel reserves.
Sample questions
What must pilots use in order to accommodate the volume of IFR traffic, according to air traffic control?
- Standard terminal arrival routes
- Local radar contact reports
- Flight management system logs
- Charted airport sketches and diagrams (correct answer)
Air traffic control (ATC) must rely on pilots to use charted airport sketches and diagrams, as well as departure procedures (DPs) that include both standard instrument departures (SIDs) and obstacle departure procedures (ODPs).
In order to accommodate this volume of IFR traffic, air traffic control (ATC) must rely on pilots to use charted airport sketches and diagrams, as well as departure procedures (DPs) that include both standard instrument departures (SIDs) and obstacle departure procedures (ODPs).
What do many charted and uncharted departures rely upon?
- Visual ground references
- Pilot dead reckoning
- Radar vectors (correct answer)
- Celestial navigation
While many charted (and uncharted) departures are based on radar vectors, the bulk of IFR departures in the NAS require pilots to navigate out of the terminal environment to the en route phase.
While many charted (and uncharted) departures are based on radar vectors, the bulk of IFR departures in the NAS require pilots to navigate out of the terminal environment to the en route phase.
Where are SMGCS charts currently available from?
- Private sources outside of the FAA (correct answer)
- The National Flight Data Center
- Air Traffic Control towers
- Federal Aviation Administration offices only
These charts are available from private sources outside of the FAA.
These charts are available from private sources outside of the FAA.
What data sources are used by Advanced Surface Movement Guidance and Control Systems (A-SMGCS) and ASDE-X?
- Visual markers and infrared ground sensors
- VHF Omnidirectional Range stations and distance measuring equipment
- Global Positioning System satellites and airport beacons
- Surface movement radar and aircraft transponders (correct answer)
The data that these systems use comes from surface movement radar and aircraft transponders.
The data that these systems use comes from surface movement radar and aircraft transponders.
How is a Category A runway incursion defined?
- A serious incident in which a collision was narrowly avoided (correct answer)
- Any unauthorized crossing of a runway holding position marking
- A minor deviation from assigned taxi instructions
- An incident involving only airport ground vehicles
Category A—a serious incident in which a collision was narrowly avoided.
• Category A—a serious incident in which a collision was narrowly avoided.
Other topics on this test
-
National Airspace System and ATC118 questionsPractice
-
Flight instruments and systems94 questionsPractice
-
Attitude instrument flying and maneuvers110 questionsPractice
-
Navigation systems and databases107 questionsPractice
-
Arrivals and instrument approaches147 questionsPractice
-
Human factors, aerodynamics and emergencies131 questionsPractice
Sources
FAA-H-8083-15B, retrieved November 16, 2026
FAA-H-8083-16B, retrieved November 16, 2026
Questions are written from the FAA Instrument Flying and Instrument Procedures handbooks. Chart-reading questions from the testing supplement are not included. ExamVerdict is not affiliated with Federal Aviation Administration (FAA). Check the official material before test day.