All tests / Ham radio Amateur Extra license exam / Electrical Principles
Ham radio Amateur Extra license exam: Electrical Principles practice
43 practice questions on Electrical Principles for the Ham radio Amateur Extra license exam. Each answer comes with an explanation and the official source.
Tests complex impedance, polar/rectangular coordinates, Q factor, resonant circuits, and AC phase angle math.
Sample questions
What can cause the voltage across reactances in a series RLC circuit to be higher than the voltage applied to the entire circuit?
- Resonance (correct answer)
- Capacitance
- Low quality factor (Q)
- Resistance
At resonance, the inductive and capacitive reactances cancel each other out, causing the current to be maximum. This maximum current leads to higher voltage across the reactances than the source voltage. Capacitance, low quality factor, and resistance do not cause the voltage across reactances to exceed the applied voltage in this manner.
E5A01 (A): What can cause the voltage across reactances in a series RLC circuit to be higher than the voltage applied to the entire circuit? Official answer A: Resonance
What is the resonant frequency of an RLC circuit if R is 22 ohms, L is 50 microhenries, and C is 40 picofarads?
- 44.72 MHz
- 22.36 MHz
- 3.56 MHz (correct answer)
- 1.78 MHz
The resonant frequency of an RLC circuit is calculated using the formula $f = \frac{1}{2\pi\sqrt{LC}}$. Substituting $L = 50\text{ }\mu\text{H}$ and $C = 40\text{ }\text{pF}$ into this formula yields approximately 3.56 MHz. The resistance value does not affect the resonant frequency, making the other choices incorrect calculations.
E5A02 (C): What is the resonant frequency of an RLC circuit if R is 22 ohms, L is 50 microhenries, and C is 40 picofarads? Official answer C: 3.56 MHz
What is the magnitude of the impedance of a series RLC circuit at resonance?
- High, compared to the circuit resistance
- Approximately equal to capacitive reactance
- Approximately equal to inductive reactance
- Approximately equal to circuit resistance (correct answer)
At resonance, the inductive and capacitive reactances cancel each other out, making the net reactance zero. Therefore, the impedance is determined solely by the circuit resistance. The other choices are incorrect because they describe conditions where reactance is significant or unequal.
E5A03 (D): What is the magnitude of the impedance of a series RLC circuit at resonance? Official answer D: Approximately equal to circuit resistance
What is the magnitude of the impedance of a parallel RLC circuit at resonance?
- Approximately equal to circuit resistance (correct answer)
- Approximately equal to inductive reactance
- Low compared to the circuit resistance
- High compared to the circuit resistance
At resonance in a parallel RLC circuit, the inductive and capacitive reactances cancel each other out. This results in the total impedance being dominated by the resistance. The other choices are incorrect because the impedance does not equal inductive reactance, is not low, and is not high compared to the circuit resistance at this specific condition.
E5A04 (A): What is the magnitude of the impedance of a parallel RLC circuit at resonance? Official answer A: Approximately equal to circuit resistance
What is the result of increasing the Q of an impedance-matching circuit?
- Matching bandwidth is decreased (correct answer)
- Matching bandwidth is increased
- Losses increase
- Harmonics increase
Increasing the Q of an impedance-matching circuit narrows the range over which good matching occurs. This directly results in a decrease in the matching bandwidth. The other choices do not accurately describe the primary effect of increasing Q in this context.
E5A05 (A): What is the result of increasing the Q of an impedance-matching circuit? Official answer A: Matching bandwidth is decreased
Other topics on this test
-
Commission Rules66 questionsPractice
-
Operating Procedures58 questionsPractice
-
Radio Wave Propagation34 questionsPractice
-
Amateur Practices60 questionsPractice
-
Circuit Components59 questionsPractice
-
Practical Circuits84 questionsPractice
-
Signals and Emissions46 questionsPractice
-
Antennas and Transmission Lines79 questionsPractice
Sources
Public release with 4th errata of February 4, 2026, released into the public domain
Current text, retrieved November 16, 2026
Exams are given by accredited Volunteer Examiner teams. Check the current pool and any errata on ncvec.org before your exam session. ExamVerdict is not affiliated with Federal Communications Commission (FCC), given by Volunteer Examiners. Check the official material before test day.