ExamVerdict

All tests / Ham radio General license exam / Practical Circuits

Ham radio General license exam: Practical Circuits practice

32 practice questions on Practical Circuits for the Ham radio General license exam. Each answer comes with an explanation and the official source.

Examines linear power supplies, mixers, superheterodyne stages, filters, and RF power amplifiers.

or practice the whole test

Sample questions

What is the function of a power supply bleeder resistor?
  1. It acts as a fuse for excess voltage
  2. It discharges the filter capacitors when power is removed (correct answer)
  3. It removes shock hazards from the induction coils
  4. It eliminates ground loop current

The bleeder resistor's main job is to safely discharge the stored energy in filter capacitors after power is turned off. Acting as a fuse for excess voltage is the function of a fuse, not a bleeder resistor. Removing shock hazards from induction coils or eliminating ground loop current are not the primary functions of this component.

NCVEC General Class Question Pool 2023-2027, Public release with 6th errata of February 4, 2026, released into the public domain, Subelement G7, group G7A, question G7A01
G7A01 (B): What is the function of a power supply bleeder resistor? Official answer B: It discharges the filter capacitors when power is removed
Which of the following components are used in a power supply filter network?
  1. Diodes
  2. Transformers and transducers
  3. Capacitors and inductors (correct answer)
  4. All these choices are correct

Capacitors and inductors are the primary components used to smooth out AC ripple into DC in a filter network. Transformers and transducers are used for voltage conversion or sensing, not filtering. Diodes are used in rectification, which precedes the filtering stage.

NCVEC General Class Question Pool 2023-2027, Public release with 6th errata of February 4, 2026, released into the public domain, Subelement G7, group G7A, question G7A02
G7A02 (C): Which of the following components are used in a power supply filter network? Official answer C: Capacitors and inductors
Which type of rectifier circuit uses two diodes and a center-tapped transformer?
  1. Full-wave (correct answer)
  2. Full-wave bridge
  3. Half-wave
  4. Synchronous

A full-wave rectifier circuit utilizes two diodes with a center-tapped transformer to convert AC to pulsating DC. The full-wave bridge uses four diodes, while half-wave only uses one diode. Synchronous rectification is a different switching technique, not defined by this specific transformer and diode arrangement.

NCVEC General Class Question Pool 2023-2027, Public release with 6th errata of February 4, 2026, released into the public domain, Subelement G7, group G7A, question G7A03
G7A03 (A): Which type of rectifier circuit uses two diodes and a center-tapped transformer? Official answer A: Full-wave
What is characteristic of a half-wave rectifier in a power supply?
  1. Only one diode is required (correct answer)
  2. The ripple frequency is twice that of a full-wave rectifier
  3. More current can be drawn from the half-wave rectifier
  4. The output voltage is two times the peak input voltage

A half-wave rectifier uses just a single diode to conduct current during one half of the AC cycle, making only one diode required. In contrast, full-wave rectifiers require multiple diodes, have a higher ripple frequency rather than a lower one, and allow more current to be drawn from the power supply.

NCVEC General Class Question Pool 2023-2027, Public release with 6th errata of February 4, 2026, released into the public domain, Subelement G7, group G7A, question G7A04
G7A04 (A): What is characteristic of a half-wave rectifier in a power supply? Official answer A: Only one diode is required
What portion of the AC cycle is converted to DC by a half-wave rectifier?
  1. 90 degrees
  2. 180 degrees (correct answer)
  3. 270 degrees
  4. 360 degrees

A half-wave rectifier only allows one half of the AC cycle to pass through. Therefore, only 180 degrees of the cycle are converted to DC. The other options represent more portions of the full 360-degree cycle, which a half-wave rectifier does not process.

NCVEC General Class Question Pool 2023-2027, Public release with 6th errata of February 4, 2026, released into the public domain, Subelement G7, group G7A, question G7A05
G7A05 (B): What portion of the AC cycle is converted to DC by a half-wave rectifier? Official answer B: 180 degrees

Other topics on this test

Sources

NCVEC General Class Question Pool 2023-2027
Public release with 6th errata of February 4, 2026, released into the public domain

Exams are given by accredited Volunteer Examiner teams. Check the current pool and any errata on ncvec.org before your exam session. ExamVerdict is not affiliated with Federal Communications Commission (FCC), given by Volunteer Examiners. Check the official material before test day.