All tests / Ham radio Technician license exam / Radio Wave Propagation
Ham radio Technician license exam: Radio Wave Propagation practice
35 practice questions on Radio Wave Propagation for the Ham radio Technician license exam. Each answer comes with an explanation and the official source.
Examines VHF/UHF line-of-sight propagation, ionospheric scatter, tropospheric ducting, and how solar or atmospheric conditions affect signal paths.
Sample questions
Why do VHF signal strengths sometimes vary greatly when the antenna is moved only a few feet?
- The signal path encounters different concentrations of water vapor
- VHF ionospheric propagation is very sensitive to path length
- Multipath propagation cancels or reinforces signals (correct answer)
- The Doppler effect causes slight frequency shifts which result in changes in signal strength
Multipath propagation causes signals to arrive at the receiver via multiple paths, leading to constructive or destructive interference. The other options describe atmospheric or propagation effects that do not cause such rapid, short-distance variations in signal strength.
T3A01 (C): Why do VHF signal strengths sometimes vary greatly when the antenna is moved only a few feet? Official answer C: Multipath propagation cancels or reinforces signals
How does vegetation affect UHF and microwave signals?
- Causes knife-edge diffraction, distorting voice peaks
- Absorbs signals, leading to poor reception of weak signals (correct answer)
- Amplifies signals, improving reception of weak signals
- Has no effect
Vegetation absorbs UHF and microwave signals, which weakens the signal strength. This absorption causes poor reception, especially for weak signals. The other options incorrectly describe signal behavior, as vegetation does not amplify signals or cause knife-edge diffraction in this manner.
T3A02 (B): How does vegetation affect UHF and microwave signals? Official answer B: Absorbs signals, leading to poor reception of weak signals
What antenna polarization is normally used for long-distance CW and SSB contacts on the VHF and UHF bands?
- Right-hand circular
- Left-hand circular
- Horizontal (correct answer)
- Vertical
Horizontal polarization is standard for long-distance CW and SSB contacts on VHF and UHF bands because it provides reliable, predictable coupling. Left-hand circular and right-hand circular polarizations are generally not the primary choice for these modes. Vertical polarization is less efficient for long-distance terrestrial communication in this frequency range.
T3A03 (C): What antenna polarization is normally used for long-distance CW and SSB contacts on the VHF and UHF bands? Official answer C: Horizontal
What is the effect of antenna cross-polarization over a line-of-sight VHF or UHF path?
- Modulation sidebands might become inverted
- Received signal strength is reduced (correct answer)
- Signals have an echo effect
- Nothing significant will happen
Antenna cross-polarization causes some of the transmitted energy to be received in a direction orthogonal to the intended polarization. This means the energy is not fully captured by the receiving antenna, leading to a reduction in the received signal strength. The other options describe effects unrelated to cross-polarization on a line-of-sight path.
T3A04 (B): What is the effect of antenna cross-polarization over a line-of-sight VHF or UHF path? Official answer B: Received signal strength is reduced
When using a directional antenna, how might your station be able to communicate with a distant repeater if buildings or obstructions are blocking the direct line of sight path?
- Change from vertical to horizontal polarization
- Try to find a path that reflects signals to the repeater (correct answer)
- Try the long path
- Increase the antenna SWR
Reflecting signals off buildings can allow communication even when direct line of sight is blocked. Changing polarization or increasing SWR will not overcome a physical obstruction. Trying the long path is not a viable solution for overcoming immediate line-of-sight issues.
T3A05 (B): When using a directional antenna, how might your station be able to communicate with a distant repeater if buildings or obstructions are blocking the direct line of sight path? Official answer B: Try to find a path that reflects signals to the repeater
Other topics on this test
-
Commission's Rules68 questionsPractice
-
Operating Procedures37 questionsPractice
-
Amateur Radio Practices22 questionsPractice
-
Electrical Principles48 questionsPractice
-
Electronic and Electrical Components34 questionsPractice
-
Practical Circuits43 questionsPractice
-
Signals and Emissions46 questionsPractice
-
Antennas and Feed Lines23 questionsPractice
-
Safety35 questionsPractice
Sources
Public release with errata of February 19, 2026, released into the public domain
Current text, retrieved November 16, 2026
Exams are given by accredited Volunteer Examiner teams. Check the current pool and any errata on ncvec.org before your exam session. ExamVerdict is not affiliated with Federal Communications Commission (FCC), given by Volunteer Examiners. Check the official material before test day.