All tests / OSHA construction safety practice test / Excavations and trenching (Subpart P)
OSHA construction safety practice test: Excavations and trenching (Subpart P) practice
51 practice questions on Excavations and trenching (Subpart P) for the OSHA construction safety practice test. Each answer comes with an explanation and the official source.
Covers 29 CFR 1926 Subpart P soil classification (Type A/B/C), sloping/benching/shoring, daily competent-person inspections, and 25-foot egress.
Sample questions
A stairway, ladder, ramp or other safe means of egress shall be located in trench excavations that are 4 feet (1.22 m) or more in depth so as to require no more than how many feet (7.62 m) of lateral travel for employees?
- 50
- 10
- 7.62
- 25 (correct answer)
A stairway, ladder, ramp or other safe means of egress shall be located in trench excavations that are 4 feet (1.22 m) or more in depth so as to require no more than 25 feet (7.62 m) of lateral travel for employees.
A stairway, ladder, ramp or other safe means of egress shall be located in trench excavations that are 4 feet (1.22 m) or more in depth so as to require no more than 25 feet (7.62 m) of lateral travel for employees.
At least one copy of the tabulated data which identifies the registered professional engineer who approved the data shall be maintained at the jobsite during construction of the protective system?
- At least one copy of the design shall be maintained at the jobsite while the slope is being constructed and thereafter stored off the jobsite.
- At least one copy of the tabulated data which identifies the registered professional engineer who approved the data shall be maintained at the jobsite during construction of the protective system. (correct answer)
- At least one copy of the design shall be maintained at the jobsite while the slope is being constructed.
- Manufacturer's specifications, recommendations, and limitations shall be in written form at the jobsite during construction of the protective system.
At least one copy of the tabulated data which identifies the registered professional engineer who approved the data shall be maintained at the jobsite during construction of the protective system. After that time the data may be stored off the jobsite, but a copy of the data shall be made available to the Secretary upon request.
(iii) At least one copy of the tabulated data which identifies the registered professional engineer who approved the data, shall be maintained at the jobsite during construction of the protective system. After that time the data may be stored off the jobsite, but a copy of the data shall be made available to the Secretary upon request.
What is the maximum width of a trench measured at the bottom?
- 10 feet
- 15 feet (correct answer)
- 4.6 meters
- 20 feet
The width of a trench measured at the bottom is not greater than 15 feet (4.6 m). This definition applies to a narrow excavation made below the surface of the ground.
In general, the depth is greater than the width, but the width of a trench (measured at the bottom) is not greater than 15 feet (4.6 m).
What is stable rock?
- Rock secured against caving-in by rock bolts
- Natural solid mineral material that can be excavated with vertical sides (correct answer)
- Rock material that requires sloping to prevent cave-ins
- Unstable rock that has been reinforced by a professional engineer
Stable rock means natural solid mineral material that can be excavated with vertical sides and will remain intact while exposed. This material does not require special securing methods for vertical sides.
Stable rock means natural solid mineral material that can be excavated with vertical sides and will remain intact while exposed.
Protection shall be provided by placing and keeping such materials or equipment at least how many feet from the edge of excavations?
- 2 feet (correct answer)
- 4 feet
- 3 feet
- 1 foot
Protection shall be provided by placing and keeping such materials or equipment at least 2 feet (.61 m) from the edge of excavations, or by the use of retaining devices that are sufficient to prevent materials or equipment from falling or rolling into excavations, or by a combination of both if necessary.
Protection shall be provided by placing and keeping such materials or equipment at least 2 feet (.61 m) from the edge of excavations, or by the use of retaining devices that are sufficient to prevent materials or equipment from falling or rolling into excavations, or by a combination of both if necessary.
Other topics on this test
-
Fall protection (Subpart M)30 questionsPractice
-
Scaffolds (Subpart L)55 questionsPractice
-
Stairways and ladders (Subpart X)32 questionsPractice
-
Electrical safety (Subpart K)45 questionsPractice
-
General safety, PPE and fire protection52 questionsPractice
Sources
Current text, retrieved November 16, 2026
This is an independent OSHA construction safety practice test based on 29 CFR Part 1926, not an official OSHA Outreach certification. ExamVerdict is not affiliated with Occupational Safety and Health Administration (OSHA). Check the official material before test day.